Evaluasi Kekuatan Struktur Atas Pada Gedung Gas Negara Fakultas Teknik Unmer Madiun Akibat Kemiringan Bangunan

Wildan Muzakky, Seno Aji, Seno Aji, Rendi Gusta Wibowo, Rendi Gusta Wibowo

Abstract


Abstract: In a building, the beams and roof frame rest on the upright standing columns of each column is a very important technical factor before the blocks and roof frame are installed. Although a column does not stand vertically, it is a serious problem that will occur in terms of construction, it should be avoided. If the angle value of deviation in the column is outside tolerance, causing difficulties in the installation of construction. The peak of the column that has shifted from its position resulted in a tilted roof frame. This measurement uses an upfront cutting method. While on the upfront cropping method use the center of the column as the target point. Thus this research has proven that the method of cutting the surface is not only more flexible, but also more useful to control the firmness of the column on building construction work. Evaluation of the strength of the upper structure of the building at the time of tilting that can be seen from the repetition of.


Full Text:

PDF

References


Abdul Khaliq (2015) Analisis Struktur Tangga Proyek Pembangunan RSUD Cideres Majalengka.Teknik Sipil Fakultas Teknik Universitas Majalengka.

Abdul Khaliq (2015) Analisis Struktur Tangga Proyek Pembangunan RSUD Cideres Majalengka.Teknik Sipil Fakultas Teknik Universitas Majalengka

Arikris Siboro,M.Yusuf,Aryanto (2017) “Perhitungan Struktur Beton Bertulang Gedung Kantor Tujuh Lantai di Pontianak”

Anonim. (1971) Peraturan Beton Bertulang Indonesia, PBBI 1971, Badan Standardisasi Nasional, Bandung.

Anonim. (1983) Peraturan Pembebanan Indonesia Untuk Gedung, PPIUG 1983, Badan Standardisasi Nasional, Bandung.

Anonim. (2002) Tata Cara Perhitungan Struktur Beton Untuk Bangunan Gedung, SNI 03-2847-2002, Badan Standardisasi Nasional, Bandung.

Anonim. (2012) Tata Cara Perencanaan Ketahanan Gempa Untuk Struktur Bangunan Gedung Dan Non Gedung, SNI 03-1726-2012, Badan Standardisasi Nasional, Bandung..

Claudia Maria P, dkk. (2016) perencanaan Struktur Gedung Hotel Jalan Martadinata Manado, Jurusan Teknik Sipil Fakultas Teknik Universitas Samratulangi, Manado.

Ir.Rudy Gunawan.(1987) Tabel Profil Konstruksi Baja,

Yuda Putra Ichwandri (2014) Perencanaan Struktur Gedung Astrama Mahasiswa Universitas Sriwijaya Palembang Dengan Penahan Lateral Dnding Struktural. Fakultas Teknik Jurusan Teknik Sipil Universitas Sriwijaya, Sumatra Selatan.




DOI: https://doi.org/10.33319/piltek.v6i2.109

Refbacks

  • There are currently no refbacks.



Indexed By :

 

Publisher :

LPPM Universitas Merdeka Madiun
Website: http://unmermadiun.ac.id
Email: lppm@unmer-madiun.ac.id / pilarteknologi@unmer-madiun.ac.id  
© Copyright 2021 PILAR TEKNOLOGI : Jurnal Teknik (Jurnal Ilmiah Ilmu-Ilmu Teknik)
ISSN 2580-3557 (Online)